Feb 13, 2012 · For example, some switch models have no shutdown as default, other models have shutdown as default. As mentioned before, using the command: you will bring the …

Jun 3, 2013 · I recently had to wrestle some switch port configurations back to default after applying to dumb settings to them. This was for a Catalyst 3750x in a stack, although it likely …

What is the default mode of cisco switch (working with 2960 - in packet tracer) ports - Access or Trunk? I read that it is by default in dynamic-auto i.e. if the connected port of the switch on the …

Jul 29, 2011 · If you do not configure the VLAN for a port in access mode, or an access port, the interface carries traffic for the default VLAN (VLAN1). You can change the access port …

Jul 18, 2014 · Lets say I have about 10 commands on the interface specifying Voice, Access, Trunk, Spanning tree – etc, and I want to quickly throw that port back to default.

You can combine selecting multiple Cisco device ports with the default command, to remove the configuration, and reset a ‘range’ of ports in one command. To do the same on a Cisco ASA …

Oct 8, 2014 · Bounce the port by shut and no shut so this answer is absolutely correct! 01-22-2021 08:25 AM - edited ‎01-22-2021 08:26 AM.

Jan 1, 2014 · By default, on a Cisco switch running IOS, the port mode on all interfaces is set to “switchport mode dynamic desirable”; this means when two Cisco IOS devices are connected …

i read somewhere the default mode is dynamic auto. now i worked in a real switch via internet it shows default mode is dynamic desirable. i tried in PT, the default mode is dynamic auto. does …

Switch ports are Layer 2-only interfaces associated with a physical port. Switch ports belong to one or more VLANs. A switch port can be an access port or a trunk port.